I have attached the test part we are machining as a JPEG. Thank you very much for your response and this definitely worked for the first and second toolpath as the machine was able to rotate the b axis to the next position and the tool 'followed' the part to the next position as it should have (with the correct x, y and z depths).īut now a new problem has arisen. I am by no means a post expert and any and all help for a rookie would be greatly appreciated. Basically, the spindle looked like it was running the correct toolpath but as if the part rotated along the top center point of the stock and not the center of rotation of the trunnion. when the machine moved to do the next toolpath at the angled surface (changing from a B0 to a B45, the x and z-axis did not compensate for the change in the parts position. I had to manually type in the M11 and M10 commands to release/hold the brakes for both axis and do it in separate lines (example below). I have gotten the A and B axis to move but had to manually change the program. So here are a few of the problems we are experiencing:ġ. We have setup the mill in a 3+2 configuration with a Tsudokoma TS-200 trunnion. First, the machine we are posting to is a Kafo Mill with a Fanuc 18-MB controller. You can purchase ROBOGUIDE off-line programming and simulation software to off-line program FANUC robots.I have been giving my best shot at creating a post processor from the generic Fanuc Post, and have gotten a fair amount accomplished (completely thanks to these forums) but i am not finding a few details for our application here and wanted to know if someone could assist. Alternatively, with FANUC, you can program your own algorithms using a PC and KAREL (programming language based on Pascal), but KAREL does not allow you to do robot movements nor edit the program from the controller’s teach pendant. 2006 Parting Out Parts For Sale Asep Wireline Parts For Sale Parting 2006 Parting out parts for sale ASEP wireline parts for sale Parting out wireline box. My question is simple, but the answer escapes me. A question that has been on my mind for some time. 0 Comments Why do you pay for PLC programming software? Why do you pay for PLC programming software? Although it occupies very little disk space and uses very little of.

A built-in ASCII editor is also available to edit, load and save TP programs in. Those who are already familiar with FANUC robots will find an identical robot programming environment with OlpcPRO. OlpcPRO includes the actual TPP editor of the robot controller for development robot TPP programs. It requires a purchased software option called ASCII Upload and it can run you $500 or more. Converting the Fanuc Robot.TP (or Teach Pendant) files to text (or.LS file) is very simple however, be aware that not all Fanuc robots will have the ability to do so.

Tpeditor fanuc download